4
2.6 . End of calibration.
到此校验完成
3. Inspection and shielding (
检验和屏蔽
)
3.1 Inspection: After completing the above one and two steps, then to
check signal input correctly. The inspection process as follows :
3.1.1. The signal sources are fed with 0 V /5V /10V signals
- The "IN" layer of the PCB board is displayed 0 /5 /10 respectively.
- The "OUT" layer of the PCB board is displays 0 /50 /100 respectively .
3.1.2 . If the above operation finished , the 0-10V signal input inspection is
correct.
As shown below :
检验
：完成以上
一
二两个步骤后进行信号输入检验。检验过程如下
信号源分别给入
0 V 5V 10V
信号
PCB
板显示板
“IN”
层分别显示
0 5 10
PCB
板显示板
“OUT”
层分别显示
0 50 100
复合以上条件则
0-10V
信号输入校正正确。
如下图所示
