Fastrax Hellfire 900, Инструкция по установке, эксплуатации и обслуживанию

Страница: 32 / 56

32
32
Ins
ta
lla
tio
n
2. Ambient Temperature Sensor
To route the sensor cable it is necessary to remove the air
intake.
2.1 Remove the 4 screws holding the extension to the
elbow. Leave the hood and extension fastened
together. Remove intake.
2.2 Mount the ambient temperature sensor inside the
air intake hood with a pair of 8-32 screws, nuts and
washers, in the location shown.
2.3 Route the cable through the screen, and down the
inside of the extension. Cut the diaphragm grommet
at the bottom of the extension and push the
connector and cable through, as shown.
2.4 Cut the diaphragm grommet on the control cabinet
and run the cable through. Insert grommet and
cable into hole.
2.5 Reassemble the intake, draw the excess cable into
the control cabinet and connect it to the mating
connector on the EMS module.
Step 2.1
Step 2.2
Step 2.3
3. Precipitation Indicator
Remove the plug from the top hole marked ‘Precipitation
Sensor’. Pass the 4-pin connector through the hole, install
lock nut and tighten.
3.1 Insert jack into mating connector.
3.2 Mount the detector on the transition duct to sensor
duct flange facing forward as shown. Heat from the
duct will keep it clear of ice and snow build up.