CÔNG TY CỔ PHẦN FASTER VIỆT NAM
Địa chỉ: 90 Khuất Duy Tiến, Thanh Xuân, Hà Nội
Website:
http://www.faster.vn/ | Email : [email protected]
Tel CSKH: 1900 54 54 52 - Trung tâm bảo hành: 1900 54 55 95
2
1. Installation instructions
1.1 Installation conditions
All the infrared sensors must be in contact with the glass surface.
No movement of the control under the glass ceramic after installation must be assured.
1.2
Printing on glass
The glass printing area over the sensors must be centred with the sensor.
Glass printing thickness in an area of 10mm around the centre of the keys <= 0.5mm.
1.3. Type of glass
The glass thickness must be 4mm.
The glass infrared light transmission wavelength range must be around 925nm.
1.4. User interface initial calibration
The User Interface has implemented an initial keyboard calibration focused to adapt the
sensibility of the keys, to the final mechanical, environmental and user conditions.
Any time the Cooktop is plugged or there is a power failure that generates a reset in the user
interface, the first time the
Key Lock
is touched the sensitivity of the keyboard is readjusted.
This first touch of the
Key Lock
must be done in certain conditions:
Do not use gloves
Use a clean finger
Touch the glass( smooth touching)
1.5. Initial Light Conditions
When power is initially applied to the Cooktop, the touch control conducts a calibration process
for the touch keys, which requires a low level of ambient light in the area of the touch keys.
If during this calibration process excessive ambient lighting is detected the User Interface
displays "FL" (Infrared Ambient Light Error) and the control calibration process is suspended.
In order to rectify the process any lighting that could affect the calibration process should be
switched off (e.g. halogen cooker hood lighting). The error will disappear when satisfactory
ambient lighting is detected and the touch control calibration procedure will now complete
satisfactorily.
Notes:
1) The "FL" error can only be generated within approximately 3s of initial power being applied
to the cooktop.
2) We recommend that the user switches off all cooker hood lighting and lighting directed
towards the cooktop when power is initially applied to the cooktop.
3) After the touch control has conducted its initial calibration process, (approx. 3s) any cooker
hood or other lighting can be switched on as normal and will not affect the operation of the
touch control.
