Faster FlowFAST H, Руководство по эксплуатации и техническому обслуживанию

Страница: 27 / 46

a D:GROUP company
00020EN Rev.09 – 12/2012 27
10 ASSEMBLING AND DISASSEMBLING INSTRUCTIONS
The Horizontal Laminar Flow FLOWFAST H cabinet is delivered not fully assembled, since the depth is greater
than the standard length of the doors, thus impossible to be introduced into the laboratories where the cabinet is
to be installed.
The FLOWFAST H cabinet is supplied in three parts, packed in the following sections:
1.
main unit
2.
work surface
3.
safety glass side panels
For an easy assembly of FLOWFAST H cabinets proceed as follows (see chapters 16 and 17):
1.
Lay the main unit [1] on the support table (if supplied - optional) previously assembled following the
instructions of chapter 16. -"Assembly diagram of support table".
2.
Place the work surface [2] on the main unit [1] in the lower part, checking that the holes of the main unit and of
the work surface fit together. Fasten them with the relevant screws and washers [3].
OPTIONAL : UV lamp has to be installed in the cabinet, proceed as follows (see chapter 19 “Assembly diagram of
UV lamp”) :
-
Put the slide guides of the curtain [22] in the housing of the stirrups for both sides.
-
Position and fix the gaskets [4B] on the whole perimeter of the glasses [4]. In this case do not consider the
following point 3. but go on from point 4.
3.
Place and fix the gasket [4B] on the three lateral support sides of the safety glass
4.
Position the upper and lower glass fastener frame [6] and screw the fitting screws hand tight [5]
5.
Place the side panels [4] and fasten the screws.-
If the FLOWFAST H cabinet is to be moved or transported into another room please disassemble it reversing the
above instructions