Close
Place Head
Load Screw
Load Screw
➊
Remove Tool
Remove the FrameFAST tool and installation head
from the durable plastic case
➋
Position the Stability Handle
Position the stability handle on the
tool and tighten by twisting
the hand grip
➌
Unlock the Thumb Lock
Position the tool upright, with the motor
gently resting on the floor and flip the
red thumb lock upwards
➍
Insert Installation Head
Insert the installation head into the end
of the FrameFAST tool. The Truss-to-Top
Plate Head is for upward installations
only, so it must be positioned as shown in the
picture. Optional installation heads for Stud-
To-Plate and Plate-To-Rim connections can be
rotated 180 degrees to accommodate both
upward and downward installations. Note:
To rotate heads that accommodate both
upward and downward installations, lift the
red thumb lock on the FrameFAST tool and
remove the head prior to rotating and then
reinsert into the end of the FrameFAST tool
and secure with the thumb lock.
➎
Connect to Power Source
Refer to the literature packet from the drill motor manufacturer (Milwaukee
or Dewalt) for detailed instructions on how to safely connect to power.
Cordless FrameFAST Tools are not provided with batteries.
Recommended batteries are as follows:
FMFFTOOL-T2TP-MILC: Milwaukee cordless option:
Suggested battery Milwaukee M18 Red Lithium XC 5.0
FMFFTOOL-T2TP-DWC: DeWalt cordless option:
Suggested battery DeWalt 20V MAX XR 5.0AH Lithium
Ion DCB205T
➏
Load Fastener
With the tool positioned vertically as shown in the
picture, load one FrameFAST screw with the tip of
the screw facing upwards.
Note: Using any screw, other than FastenMaster
FrameFAST 6" threaded screws, is not
recommended and will void the limited warranty
on the FrameFAST tool and installation heads
➐
Installation
Set the screw gun to "forward" and the speed
to #2. Refer to screw gun manufacturer's
instructions for more detailed instructions
related to the operation of the screw gun.
For Truss-To-Top Plate installations, position the
FrameFAST tool such that the front edge of the
installation head is flush with the vertical face
of the wall plate. Once the tool is properly
positioned, press firmly forward to set the
positioning cleats. This will stabilize the tool for
precise installation angle and offset.
Next, pull the trigger on the screw gun and
drive until the telescoping FrameFAST tool is fully compressed. When the screw has
been driven to the proper depth it will automatically disengage from the driver bit
Twist
Lift Thumb Lock
How to Set up Tool
