Fast MT765 Challenger, Инсталляционные компоненты

Страница: 10 / 31

INSTALLATION & PARTS
INSTALLATION Track Tank MT765 Challenger Page 10
3. Place the rubber isolators (4) on the
top and bottom of the bracket.
4. Place the plate (5) on top of the
isolator and insert four 3/4” x 9” GR5
bolts (6) through the plate and both
isolators.
5. Repeat Steps 3 and 4 for the left-
hand side receiver mounting bracket.
WARNING: Receiver mounting
tube weighs approximately 150
lbs. Use an appropriate lifting
device to prevent injury.
6. Raise the receiver mounting tube (7)
into position with the radar bracket to
the rear and install eight center-lock
nuts (8).
7. Tighten all eight bolts equally (1/8” –
1/4”) so some bulge is seen on the
rubber isolators.
Install Underside Supports
WARNING: Frame bracketry
weighs approximately 300 lbs. Use
an appropriate lifting device to
prevent injury.
1. Install the right-hand underside
support (2) onto the receiver
mounting bracket (1) with four 3/4” x
2-1/2” GR8 flange bolts (3) and
flange nuts and four 3/4” x 2” GR8
flange bolts (4) and flange nuts. Refer
to the torque charts in this Manual for
bolt torque values.
2. Repeat the procedure for the left-
hand side.