Operating Manual
Aqua M40
F.A.S.T GmbH
A40 2014
F.A.S.T. GmbH
Bössingerstrasse 36
D- 74243 Langenbrettach
Page 7
5
Activating the Bluetooth connection
5.1
Initial connection
To bring the central unit into the pairing mode, push and hold the frequency button and
thereafter the On/Off button. Wait until the Bluetooth LED is flashing and then release the
two buttons. Now the old connections are deleted.
•
The central unit is now in pairing mode
To bring headphone into pairing mode, push the “Power” key for 7 seconds until the red and
blue LED is flashing alternately.
•
The headphone is now in pairing mode
During pairing process, hold the headphone and the central unit in direct proximity. When the
connection is established, the Bluetooth LED at the central unit will glow permanently and
the headphone will indicate the established connection with a double “Piep” and accordingly
the blue LED will flash in a 5 second intervall.
5.2
Re-activating a Bluetooth connection
Once a headphone and a central unit has been paired (coupled), the two devices will find each
other automatically after you switch them normal on.
Additional information for new Headphones Marmitek Boom Boom 560
The Bluetooth connection between the Aqua M40 and the Marmitek Boom Boom 560 needs
to be established as following. First switch on Aqua M40 and then press and hold the power
button on the headphone until the Bluetooth-LED on the Aqua M40 indicates connection
(LED is lighting). If you release the power button to early there will be a long beep tone
audible and the Aqua M40 will indicate Bluetooth connection but no sound is audible. If this
happens, switch the headphone off and repeat the process.
5.3
Delete a Bluetooth-connection
To delete a established connection, or to connect the central unit with a different headphone,
push and hold the frequency button and afterwards the On/Off button. Wait until the
Bluetooth LED flashes and then release both buttons. Now all connections are deleted.
