Fast 8295RT, Инструкция по установке и каталог запасных частей

Страница: 11 / 18

11
Install Step Assembly
1. Install top step bracket (1) with four 5/8 x 1.5 '' carriage
bolts (2) and (3), and flange nuts. Refer to torque charts
in this instruction for bolt torque values.
2. Remove six bolts (4) and existing top step. Install new top
step and attach with six bolts previously removed. Refer
to torque charts in this instruction for bolt torque values.
3. Install step support tube (6) as shown into receiver on
left-hand tank. Do not tighten setscrews at this time.
^
WARNING
Step assembly weighs approximately 300 lbs.
Use an appropriate lifting device to remove
step assembly.
4. Attach lifting device to step assembly.
5. Raise step assembly into position and attach to top
bracket (1) with 5/8 x 1.5'' carriage bolts (7) and 5/8'' lock
washers and nuts.
6. Attach to support tube with existing carriage bolts (8) and
flange nuts.
7. Adjust step and tighten all step hardware and setscrews.
Refer to torque charts in this instruction for bolt torque
values.