The installation of the electrical harness is done first, allowing power to be applied to the pump for
lubrication purposes.
d. Route WH-1005 wire harness along frame rail to mounting location of pump.
Completion of this step
will be addressed in the Step 3.
56
WH-1005 Schematic
c. Secure Relay in an upright position, as shown, to prevent moisture from entering. Di-electric grease may
be applied to prevent corrosion.
a. Connect the WE-1008 Fuse Tap Extension to the WH-1005’s shorter relay branch. Route the extension to
the engine bay fuse panel. Remove a fuse (maximum of 10A) that is “hot” when the key is on. Example:
#54 or #55.
Use a test probe to locate the “hot side” of the circuit in the fuse block.
Install the fuse tap
into the open location. Install the pulled fuse into the open space on the fuse tap. Disconnect the battery
then continue installation
.
Neg.
Pos.
b. Using ring terminals, attach the two power wires of the WH-1005 to the battery.
The use of corrosion
preventative spray is recommended.
Attach red to the positive and green to the negative. Secure fuse
block in a location protected from outside elements.
