A.
Route fuel line to the suction port on the FASS pump labeled
“T”. Cut the fuel line. Insert PL-1005 into fuel line using oil. At-
tach to 10-300 in ‘T’ port. Torque to 18 ft./lbs.
C.
Insert PL-1005 into fuel line. Attach to 10-300 located in the
port labeled “E”. Use oil. Torque to 18 ft./lbs. Route this line to
the inlet port of the factory filter housing.
B.
Install in-line fuel filter in an accessible location in the suction
line using the HC-1001’s. Make sure the fuel flows in the direc-
tion of the arrow on the canister.
D.
Measure and cut fuel line. Insert PL-2003 90° Push-Lok fitting
using oil.
E.
Disconnect factory fuel line and injector return line from inlet
side of the factory fuel filter and install the DIPF-1003. Torque to
18 ft./lbs.
Do Not use sealant on AN (male flare) fittings. Only use sealant on threads installed into pump assembly.
Note: Inline filter will need to be replaced every 6,000 miles.
