Fasep 2000 srl
Rev. 1.6
Videotronic V548.G4: User’s Manual
15 April 2019
19
C:
Errors and Malfunctions recognized by the Computer
Errors may apply to some model only.
ERR 1:
Shaft does not rotate
ERR 2:
Rotation Direction is wrong
ERR 3:
Rotation speed is not ready
ERR 4:
Rotation speed is wrong (too low or too high)
ERR 5:
Position Sensor or Position Disk failure
ERR 6:
Safety cover is open
ERR 7
:
Measuring cycle was interrupted
ERR 8:
Calibration weight was not inserted.
ERR 9:
Activation code not correct
ERR 10:
Overflow in calculations
ERR 11:
Serial number is wrong
ERR 12:
Serial number not inserted
ERR 13:
Reserved
ERR 14:
Incorrect password
ERR 15:
E²prom error
ERR 16:
Calibration memory error
ERR 17:
Rod in incorrect position
ERR 18:
Excessive weight detected
ERR 19:
Hand spin interrupted
ERR 20:
wrong speed due to strong deceleration
ERR 21:
Error in inputting data
ERR 22:
Brake error
ERR 23:
Reserved
ERR 24:
PL shaft open
ERR 25:
Reserved
ERR 31:
Activation code not valid
ERR 32:
Service Warning / Lock
ERR 33:
Calibration check out of range
ERR 34:
Input gauge not in home position
ERR 35:
Width Input gauge not in home position
ERR 37:
1137 board not found (formerly numbered Error 35)
ERR 42:
Can not back up or restore 27C16 memory information
ERR 46:
Memory not Found (Start of the program that fails to read or write to memory, both in 24C16 and 1150 modes)
