Fasep V548.G4.U, Руководство пользователя

Страница: 20 / 23

Fasep 2000 srl Rev. 1.8
Videotronic V548.G4.U: User’s Manual 11 March 2022
19
C: Errors and Malfunctions recognized by the Computer
Errors may apply to some model only.
ERR 1: Shaft does not rotate
ERR 2:
Rotation Direction is wrong
ERR 3:
Rotation speed is not ready
ERR 4:
Rotation speed is wrong (too low or too high)
ERR 5:
Position Sensor or Position Disk failure
ERR 6:
Safety cover is open
ERR 7 : Measuring cycle was interrupted
ERR 8:
Calibration weight was not inserted.
ERR 9:
Activation code not correct
ERR 10:
Overflow in calculations
ERR 11:
Serial number is wrong
ERR 12:
Serial number not inserted
ERR 13:
Reserved
ERR 14:
Incorrect password
ERR 15: E²prom error
ERR 16: Calibration memory error
ERR 17: Rod in incorrect position
ERR 18: Excessive weight detected
ERR 19: Hand spin interrupted
ERR 20: wrong speed due to strong deceleration
ERR 21: Error in inputting data
ERR 22: Brake error
ERR 23: Reserved
ERR 24: PL shaft open
ERR 25:
Reserved
ERR 31:
Activation code not valid
ERR 32:
Service Warning / Lock
ERR 33:
Calibration check out of range
ERR 34:
Input gauge not in home position
ERR 35:
Width Input gauge not in home position
ERR 37: 1137 board not found (formerly numbered Error 35)
ERR 42: Can not back up or restore 27C16 memory information
ERR 46: Memory not Found (Start of the program that fails to read or write to memory, both in 24C16 and 1150 modes)