1
ASSEMBLY INSTRUCTIONS
Please keep these instructions for future reference. Adult assembly required.
This table is not a toy & is intended for use by or under the supervision of adults.
Please do not sit, climb or lean on the table.
This table is intended for indoor use only.
1.
Find a clean & level place to begin the assembly of your OYSTER table football game. You will need
a Phillips screwdriver, a 13mm spanner & a hammer. Remove all parts from the box & save all
packing materials until the parts have been inspected & the table is assembled.
2.
Attaching the legs – place the table onto the floor facing the correct way up & then stand it upright
on one of the ends. Important – this should be carried out by 2 adults. If easier, turn the table
upside down onto the floor.
3.
Fix the legs into the slots underneath the table using the bolts & nuts provided. Fit the rubber feet to
the bottom of each of the 4 legs.
Insert the coach bolts into the sides of the table followed by a nut. The square neck of the bolt will
not fit into the round hole. Tighten the nut so that the neck breaks into the laminate but do not over-
tighten – this will not cause the laminate to crack. The mushroom head of the bolt should just touch
the laminate surface.
