Farymann Diesel 15W Series, Руководство по ремонту, Страница: 47 / 80

REASSEMBLY PROCEDURES
- 47 -
Now press the camshaft with a driver into
the bearing. Use another driver as counter
pressure piece for the bearing. Make sure
that the bearing sears fully against the seat
flange. Insert retaining ring. Install camfol-
lower for the injection pump and tighten the
fixing screw.
Every time install a new o-ring on the cam-
shaft prior to pressing the camshaft into the
bearing.
9. Governor control
Insert ratched pin and spring into the hole in the
gear end housing.
Put the return spring (1) into small hole of the
control lever.
Move the torsion spring (2) over the eccentric
shaft and hook spring leg in the space in the
middle of the ratched plate (3).
Slide the eccentric shaft through the bearing
bush in the housing and into the control lever.
Turn the acceleration lever downwards (“stop”)
until spring leg of the return spring can be
moved into the notch of the eccentric shaft end.
(Figure c).
c
Push in eccentric shaft and clip ring spring into
Use a wire loop to move and hook torsion spring
leg to the boss of the gear end housing.
(Figure d)
d