15.
Sync Termination Switch
– Select ON when
15.
not looping the Composite Sync signal to
other video devices, (75 Ohm).
16.
Sync Input Loop (BNC)
– Composite Sync
Input Loop
17.
Sync Input (BNC)
– Composite Sync Input
18.
Red Output (BNC)
– Red Output 714mV
19.
Green Output (BNC)
– Green Output 714mV
20.
Blue Output (BNC)
– Blue Output 714mV
21.
Horiz. Sync Output (BNC)
– Horizontal Sync
Output –4Vp-p, 31.5KHz/31.2KHz
22.
Vert. Sync Output (BNC)
– Vertical Sync
Output –4Vp-p, 59.49Hz/50Hz
23.
Sync Output (BNC)
– Composite Sync
Output –4Vp-p
24.
VGA Interface Output
– VGA Standard using
Positive TTL Sync Levels. See appendix B for
pinout information.
25.
Remote Control Interface
– See appendix A
for interface diagrams.
26.
Power Input
– 100-250 VAC, 50/60Hz, 60W
Interface
Figure 4 diagrams the installation of the LD100
using inputs from:
1. A composite source such as a Laser Disk Player,
VCR or TV Receiver.
2. A Y/C input such as a S-VHS VCR.
3. An RGB input with sync on green or a
Component input such as a Camera or Beta-SP
recorder with sync on Y. If sync on green or sync
on Y is not available then Sync can be interfaced
using the Composite sync input.
All input with the exception of the Y/C input have
selectable 75 Ohm input termination switches.
These switches are to be in the ON position unless
the LD100 is being used in a looped configuration.
Termination is then located at the last unit in the
loop only.
Note: The diagram shows a 5 wire connection to
the monitor/projector, i.e. Red, Green, Blue,
Horizontal Sync and Vertical Sync. For monitors/
projectors with a 4 wire input, use Red, Green, Blue
and Composite Sync outputs.
The monitor/projector will be terminated at 75 Ohm
either internally or by switches located on the moni-
tor/projector.
9
Figure 4
