DVP-1080 FAQ’s
REV 06.20.05
Pearcision
12
•
Adjust all applicable changes required for the intended
PROFILE
•
Under the menu tab
INPUT
,
use the
[
▼
]
arrow button to highlight
PROFILE
•
Press the value
[
►
]
button to select numeric PROFILE
•
Press
the
[STORE]
button
•
Press
the
[MENU]
button to exit the
On-Screen Display
D.4.
When I select 4:3 on the IR remote, the image is not centered.
This essentially means the innate 16:9 image from the DVP-1080, when selecting
ANAMORPHIC
, is not
properly centered on the display device.
•
Utilize a DVD ‘Screen Area’ test pattern (DVD Essentials, AVIA, etc.)
•
Center, and position the image for a 2.5% over-scan, using the displays sizing and positioning controls.
•
Once the image has been properly centered, sized and positioned (utilizing the display controls), the 4:3
image will fall-in-to-place and be centered within the 16:9 display area.
Note:
Do not view a 4:3 images for prolonged periods of time on a 16:9 display; image
Burn-In
may occur.
Image
Burn-In
is not covered under the Faroudja Warranty.
D.5.
The DVP-1080 has locked up. How do I reset the processor?
There are three options available to re-boot the processor.
Level ONE:
Set the DVP-1080 unit in
Stand-By
mode; LED indication is
RED
. Disconnect the power plug from the
processor; reconnect the power plug to the processor and allow the unit to re-boot.
Level TWO:
•
Enter
the
SETUP MENU
by pressing the
[MENU]
button on the IR remote for seven (7) seconds
•
Press
the
[
▲
]
button on the IR remote once
•
LCD display will indicate
SET: RESTORE FACTORY / <PRESS STORE KEY>
•
Press
the
[STORE]
button on the IR remote
•
Front Panel LCD display will indicate
ARE YOU SURE?
•
Press
the
[STORE]
button again to confirm
Note:
This action will clear all programmed
PROFILES
and reset the DVP-1080 to Factory Defaults.
Level THREE:
Connect to the DVP-1080
RS-232 CONTROL
port using Windows HyperTerminal program and a standard
Modem Cable (please see FAQ instructions:
“
How do I enter the RS-232 command string?”
).
TYPE
dvp,setft
[
↵
Enter]
[
↵
Enter]
denotes a carriage return, or pressing
[
↵
Enter]
button on the keyboard
Note:
This action will clear all programmed
PROFILES
and reset the DVP-1080 to Factory Defaults.
Main Menu
Main Menu
Main Menu