5
F a r m T e k ®
If you have any questions, please call
us toll free at 1-800-FARMTEK.
TWIST-OF-THE-WRIST ASSEMBLY (continued)
9. Slide the Twist-of-the-Wrist mounting plate over the
long bolts and secure the plate with two lock nuts.
10. Attach the Twist-of-the-Wrist gearbox to the mounting
plate using hex head bolts included with the plate.
NOTE:
The number of
bolts used to secure
the gearbox to the
mounting plate may
differ from what is
shown in the diagram.
NOTE:
Photo shows
a different bolt and
nut. Secure as
instructed using the
1/4" nut and bolt.
11. Using a 1/4" x 2" bolt and 1/4" locknut, attach the
square shaft to a tubing adapter.
12. Slide the square shaft through the Twist-of-the-Wrist
gearbox.
13. Slide the Twist-of-the-Wrist assembly onto the
aluminum channel from the ground end. (This is the
free end of the channel.)
14. Align the roll-up conduit with the gearbox and trim roll-
up conduit to length as needed.
15. Check clearance between channel and the structure
that the channel is attached to. Adjust if needed.
16. Attach the roll-up conduit to the square shaft of the
assembly by inserting a 1/4" x 2" bolt through the hole
in the conduit and tubing adapter. Tighten the locknut.
17. Straighten the curtain and center it along the shelter or
building side as needed.
Fabric Clips
All parts are not shown
in this diagram.
Trim roll-up conduit to
length as needed.
