21
GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
Revision date: 06.20.18
Complete following general steps to install end wall panels.
1. Consult panel location diagrams, select one
polycarbonate panel, begin at edge of door opening,
and work to the outside edge of end wall.
END PANEL INSTALLATION (continued)
Mark UV Side
X
Dashed line and arrows show where to install white
vent tape.
NOTE:
Remove protective film. When needed, an
upper panel is cut to length
after
attaching it to end wall
frame and rafter.
2. Measure and cut Panel A to proper size using rafter as
a guide.
NOTE:
Remainder of 4' x 12' panel
is used to cover the
area along other side of door.
Always remove protective film and mark and install UV-
protected side to outside of greenhouse.
3. Apply white vent tape to bottom of panels and then
install aluminum U-channel profile to panel edge
adjacent to door as shown on Polycarbonate Panels
diagram in Quick Start section.
4. Place
Panel A
in position, add H-channel along outer
edge, and attach to end wall framing using long Tek
screws (FA4484B).
Cut from a
4' x 12' Panel
Not to scale.
A
NOTE:
Consult end wall diagrams located in Quick
Start section for on-center dimensions.
Remember to
account for installation of H-channel.
Some door designs allow for the installation of the
adjacent panel behind door frame.
U-profile here.
A
H-channel here.
H-channel here.
