17
Revision date: 08.26.15
6
SECURE TOP TO THE MAIN SUPPORT FRAME
Assembly Instructions
ATTENTION:
Actual bench may differ from what is shown.
Consult the Quick Start Guide for your bench details.
1. Square the bench top on the support frame.
ATTENTION:
Verify that each side is equal
distance from the 1.25" x 1.25" support tube.
Ends of top will rest on the ends of all long
support tubes.
4. Repeat Steps 2-3 to install a clip at each of the
remaining corners of the bench top to secure
top to the support tubes. See next photo for
location of clips.
2. Move to a bench top support closest to the
bench legs near one end and attach a 112431
clip to the outer support tube.
NOTE:
Use a piece of tape to hold clip for
easier installation.
ATTENTION:
Install a total
of four (4) clips to secure
the top. Actual location may
differ from what is shown.
Install two near each end on
the underside of the bench
top to secure top to the long
support tubes.
5. Inspect the bench to ensure
that all fasteners are installed
and tight.
6. Assembly is complete. Use
the bench.
3. Once the clip is attached to the support tube,
install another Tek screw to secure the clip to
the tube. Actual frame may differ slightly.
NOTE:
Screw should be snug. Do not over-
tighten. Doing so can strip threads.
Install clips on
the underside of
the frame.
