POLY BUILDINGS
4
Revision date: 03.15.12
REQUIRED TOOLS
The following list identifies the main tools needed to
assemble the shelter. Additional tools and supports may be
needed depending on the structure, location, and
application.
• Tape measure or measuring device
• Marker to mark locations on the pipes
• Variable speed drill and impact driver (cordless with
extra batteries works best)
• Metal-cutting tool for pipe
• Wrenches or ratchet and socket set (recommended)
• Hammers and gloves
• Adjustable pliers
• Plumb Line
• Utility knife, scissors (or similar cutting tool)
• Ladders, work platforms, and other machinery for lifting
designed to work safely at the height of the shelter
QUICK START GUIDE
For a quick overview of the shelter and its components,
consult the Quick Start diagrams at the back of these
instructions.
UNPACK AND IDENTIFY PARTS
The following steps will ensure that you have all the
necessary parts
before
you begin to assemble the shelter.
1. Unpack the contents of the shipment and place where
you can easily inventory the parts. Refer to the Bill of
Materials/Spec Sheets.
2. Verify that all parts listed on the Bill of Materials/Spec
Sheets are present. If anything is missing or you have
questions, consult the Pictorial Parts Guide and all
shelter diagrams for clarification, or contact Customer
Service.
NOTE:
At this time, you do not need to open the plastic
bags containing smaller parts such as fasteners or
washers.
SQUARE THE SITE
1. Identify a corner where a building rafter will be
positioned, drive in a stake, and string a line the exact
width of the building and stake in place.
2. String a line at least as long as the building from the
first stake at 90°.
NOTE:
A transit can be used to ensure an accurate 90°
angle, or the 3-4-5 rule can be used. Refer to diagram.
Using multiples of 3-4-5 such as 6-8-10 or 12-16-20
helps to maintain an accurate 90° angle.
3. After squaring the position of the building and placing
a stake at all corners, string a line between the stakes
to mark the base of the building.
ATTENTION:
The use of the above method depends
on the shelter design and shelter length. Squaring
the site helps position the frame during assembly for
shelters exceeding 10' in length.
LAY OUT THE BUILDING SITE
After the site is prepared, identify the location of the shelter
corners helps to square the frame after it is assembled.
Taking these steps
before
assembling the shelter saves
time and ensures that the structure is positioned as
desired. The following procedure is a suggested method. Its
use depends on the size of the shelter, shelter application,
the footings, and the method used to anchor the shelter
