Farmi 381 HF, Руководство по эксплуатации, техническому обслуживанию и запасным частям, Страница: 26 / 72

FARMI 381 HFC / HF
26
ITEM ACTION
MAINTENANCE
INTERVAL
NOTES
Chipper frame and
knife units
Tighten pins and nuts Weekly All pins and nuts must be tightened
after the first operating hour! For the
torques, see the table.
Check twig breaker
and additional knife
At the time of knife
maintenance
Check the twig breaker and the addi-
tional knife for breakage.
Hydraulic system Replacement of
the return filter
500 h
Oil change 1500 h First oil change after 80 operating
hours!
Check timing belt 250 h If necessary, tighten according to
instructions.
Check hydraulic hoses
and joints
Daily
Grease nipple:
1. PTO drive shaft
Lubricate Daily See separate instructions
2. Rotor bearing Lubricate 50 h 5-6 pump strokes / bearing
3. Swing bearing of
the roller swing
Lubricate 50 h
4. Lifting cylinder of
the roller swing
Lubricate 50 h
5. Bearing of
the material feed
Lubricate 50 h
6. Opening cylinder of
the upper housing
Lubricate 250 h
7. Swiveling cylinder
of the discharge pipe
Lubricate 250 h
8. Lifting cylinder of
the material feed
Lubricate 250 h
Electrical system Check lines and
connectors.
Weekly
Lubricate electrical
connectors
250 h Spray anti-oxidant onto the connec-
tors.
Feed unit Check the tension of
the feed unit.
50 h If necessary, tighten according to
instructions.
Check the sliding
plates for damage.
50 h
MAINTENANCE