Farmi Forest W30F, Руководство по эксплуатации, техническому обслуживанию и запасным частям

Страница: 20 / 39

20
W30F
WINCHING
1. The winch is equipped with a clutch, which will be used by the control rope. When the user draws the control
rope, the winch begins to draw in the cable. Winching will stop when the rope is released.
2. The end of the cable drum is equipped with a friction clutch, which slips, if the load is too heavy. This prevents
cable break or damages if the load gets caught.
3. The cable can be pulled out when the latch is released.
4. Once the latch is released, it will stay released until the operator has engaged it again by pulling on the latch rope.
Fig. 6.
Controls
OPERATION
SAFETY PRECAUTIONS
Read the operation instructions before operating this machine! It is the owner’s
responsibility to instruct all equipment operators and support personnel in the
operation of this winch.
WARNING!
1. Choose a horizontal, hard based skidding route for the tractor. Avoid steep slopes, especially when winching from
the side. Check that the winching trail is clear and that the tra ctor’s parking brake is on. Do not run the tractor at
a high idle when winching. Maximum P.T.O speed is 540 rpm. Ensure that the logs can be drawn freely. Be
especially careful when working on slopes. Avoid winching sideways at angles exceeding 30 degrees. Use diverting
pulley which is fastened to the tree if needed. (See fig. 9.)
2. The safest place for the operator is at the back left side of the winch, allowing good visibility (See fig. 7). Take care
that there is no one in the working area.
3. The tractor must have a ROPS cab and rear end weights.
a. Always position the tractor on a flat ground in line with the direction of the pull (see fig. 7.). Avoid
working in steep terrain. Ensure nothing is blocking the path of trees.
b. Avoid an unnecessarily strong pulls, the tractor may roll over.
c. Adjust the tractors rpm’s according to the conditions.