
22
CH18
THE OPERATING SWITCH
Hydraulic feeder is operated by switch,
which is located on the top of the feed
chute next to emergency stop button.
SETTING THE FEEDER SPEED IF NEEDED
Do not set the feeder speed when the feed rollers are revolving. This damages the
valve. Stop the feed rollers for the duration of the setting and try the speed
afterwards
WARNING
1.
Using the flow control valve, set the
revolution speed of the feed roller to
correspond with the cutting speed of the
blades. By turning the knob clockwise, the
feed roller speed decreases but knife disc
speed increases. By turning the know
counterclockwise, the feed roller speed
increases and knife disc speed decreases.
2.
The speed is suitable when the wood does
not push against the knife disc or the feed
roller does not slow down the feeding of
wood.
3.
Make sure that you are using clean oil in
the hydraulic system. Dirt in the oil will
damage valves and hydraulic motors
+ -
Содержание CH18 PTO
