Farmi Forest CH10, Руководство по эксплуатации, техническому обслуживанию и запасным частям

Страница: 21 / 48

CH10 21
M12X30
M12 DIN 315
EMPTYING THE CHIPPER AFTER USE
Let the chipper run empty by operating it for a short time.
SWIVELING THE FEED HOPPER TO THE
TRANSPORT POSITION
1. Attach the feed hopper to the chipper using an
M12x30 hexagon head bolt and an M12 butterfly
nut. See the figure showing how the feed hopper is
swiveled to the transport position.
STORAGE OF THE CHIPPER
• Before detaching the chipper from the tractor, park it
on level and hard ground. Take appropriate measures
to prevent the chipper from moving or falling.
• If the chipper is to be stored for a long period, lub-
ricate the knives e.g. with petroleum jelly.
• Take appropriate measures to keep the wa-
ter drainage holes on the lower chamber open.
Fig 6. Swiveling the feed hopper to the transport position
Screw
Butterfly nut
MAINTENANCE
Before beginning maintenance and
repair
• place the chipper onto level and hard ground and
make sure it cannot tip;
• turn off the tractor and disconnect the PTO drive
shaft;
• disconnect the hydraulic hoses from the tractor;
• familiarize yourself with the machine-specific main -
tenance and repair instructions. In case of doubt,
please contact the manufacturer.
• Always lock the rotor before adjusting or changing
the knives.
• Always wear protective gloves when handling knives.
PERIODIC INSPECTIONS
• With new machines, check the mounting bolts for
tightness after the first operating hour, tightening
them if necessary. Tightening torques are shown in
table.
• Check the mounting bolts for tightness once a week.
• The knife-to-anvil clearance is adjusted to the speci-
fied values. For instructions on adjusting the clearan -
ce, see Adjusting the knife-to-anvil clearance.
WARNING