Manual
TURBULENT 3 | TURBULENT 5 | TURBULENT 6
22
│
27
7.
MACHINE STORAGE
Long-term machine shutdown:
Store the machine under a roof if possible.
Store the machine on a flat and solid surface with sufficient load capacity.
Clean the machine before storing and conserve so that it is not damaged in any way during storage. Pay special
attention to all marked lubrication points and properly lubricate them according to the lubrication plan.
Store the machine in the position with folded frames in the transport position. Store the machine on the axle and
the storage leg, secure the machine against spontaneous movement using scotches or another suitable tool.
When storing, lower the machine into the lower position using hydraulics.
Lock the piston-rods by means of
ball valves.
The machine must not be supported by the shares. There is danger of machine share damage.
Secure the machine against access of unauthorised persons.
8.
MACHINE LUBRICATION SCHEDULE
During machine maintenance and its lubrication, it is necessary to observe the safety regulations.
Table 4 – Places and intervals of lubrication
LUBRICATION POINT
INTERVAL
LUBRICANT
Tow bar joint
Fig. 8
- Daily, always before the work with the machine.
- Always after the end of works during machine
storing.
- Always before storing the machine (for a period,
when the machine will be stored without work).
Plastic grease
K EP 2 - 30
dle DIN 51 502
Disc bearings
Fig. 9
Tyre roller bearings
Fig. 10
Fig. 8 - Tow bar joint
Fig. 9 - disc bearings
Fig. 10 - Tyre roller bearings
Lubricant handling:
Protect yourselves against direct contact with oils by
using gloves or protective creams.
Thoroughly wash oil spots on the skin using warm
water and soap. Do not clean the skin with petrol,
engine diesel fuel or other solvents.
Oil is poisonous. If you swallowed the oil,
immediately seek a physician.
Protect the lubricants against children.
