Manual
TRITON TRNH 300 P
28
│
38
SETTING THE WORKING DEPTH OF THE CHISELS DURING WORK WITHOUT THE ROLLER
▪
When working without the rollers, the depth can be set using the transport axle.
▪
Working without rollers is especially convenient when the conditions are wet, or when a coarser soil
structure is required, for example, in winter.
▪
It is forbidden to work on the axle when the rollers are lifted; the rollers must be disassembled for work.
▪
The depth is set by clips on the axle piston-rods.
▪
Set the depth according to the sticker on the axle and check the setting during work.
▪
Removing the small washer (dark blue, 13 mm) increases the working depth by about 30 mm; the large
washer (grey, 25 mm) increases the depth by about 55 mm.
Both piston-rods of the axle must have the same number of clips!!!
Examples:
Working at a chisel depth of 25 cm:
1. Set nine washers on both piston-rods of the roller.
2. Set the tractor arms at a position so that the main frame of the machine is horizontal with the ground.
Working with a chisel depth of 17 cm with disassembled rear roller:
1. Place 4 grey clips and 2 blue clips on the piston rods of the transport axle.
2. Set the tractor arms at a position so that the main frame of the machine is horizontal with the ground.
