Manual
SOFTER 4,5 NS | 6 NS
14
│
21
5.1
MACHINE WORKING DEPTH ADJUSTMENT
The working depth is set by changing the position of the rollers against the frame of the machine. This
change is executed either mechanically using drawbars or hydraulically using piston-rods according to the
version of the machine.
Setting the depth using drawbars
1.
Set the working depth using the top pin on the slotted piece of the rear frame of the roller according to
Tab. 5. To release the pin, the machine has to be lifted in the arms of the tractor.
Tab. 5 – Setting the working depth
2.
When placing the machine on the roller, the bottom pin on the slotted piece of the rear frame must be
adjusted as close to the stop piece as possible. By positioning the tractor lower arms and adjusting the
third point bar of the tractor, the longitudinal plane of the machine is set, and thus an even working
depth of the first and second row of the discs is secured.
SOFTER 4,5 – 6 NS
Position of the
top pin
Approximate depth
[mm]
1
30
2
40
3
50
4
65
5
80
6
90
7
100
8
110
9
120
