Manual
KOMPAKTOMAT K1250PS | K1570PS
30
│
46
The height of the front leveller is set in relation to the size of the clods and the field unevenness. The
height of the leveller has to be adjusted according to the current conditions. When the leveller is too
low, it will drag too much soil along, which reduces the tractor output. When the leveller is too high, it
will not work, which will affect the final quality of work of the machine. We recommend to keep the
leveller approx. 3cm above the surface when the machine is lowered down to the working rollers.
9.2.1
FL + FH – Front fixed serrated levelling bar
The automatic release of the leveller is protected by a draw spring. The spring is factory-set to the
length of 340mm; however, it is possible to change the preloading as needed. The spring preloading is
selected according to the character of the field (size of clods in the field). The bigger the clods are, the
higher the preloading needs to be.
Use an auxiliary control lever to make the manual leveller height setting easier.
9.3
Adjusting the components of RING rollers
The design of the special roller versions require adjustment in order to provide quality soil processing.
Always adjust the rollers when the machine is in standstill and observe generally valid labour safety
regulations.
To keep the quality of soil processing, the position of the digital deflectors against the ring roller must be
adjusted.
Adjusting the position of deflectors can be highly individual. It depends on the soil and climatic
conditions.
Min.320mm
Max.370mm
