Manual
KOMPAKTOMAT K1250PS | K1570PS
18
│
46
Checking the nuts on the transport axle
Use the plastic arrow “Check Point” to check for loose nuts. It promptly shows the condition of the
nuts, whether they are loose or not.
Always check the Check Points before driving.
When the arrows are not facing one another, the nuts have to be tightened to the required torque and
the Check Point arrows have to point against one another as shown in the green picture.
Torque for the axle nuts:
M18x1,5 - 265Nm
M20x1,5 - 343Nm
M22x1,5 - 440Nm
5.
SETTING TO WORK
When aggregating the machine with the tractor and setting it to work, the steps given in Chapter E, F
/Page 5 to 6 should be followed.
Aggregate the machine with a tractor with the use of the bottom hitch with a
50 mm or
70 mm
bolt or with K80 tow ball.
Place the trail cultivators on the chassis so that they cultivate the compacted layer of soil made by the
tyres of the chassis and the tractor. The range of the position of cultivators may be selected even for
tractors with a pair assembly, i.e. up to the width of 3.9 m. The maximal recess of cultivators is 60 mm
below the level of the tractor wheel trail.
To interconnect the hydraulic systems, use the quick-couplers of the identical model (the socket on the
machine and the plug on the tractor) - the machine is normally provided with the ISO 12.5 quick
couplers.
Always fold and unfold the machines on a flat surface. Or meet the requirement of the P100H safety
label (see p. 10).
Attach the hoses of the individual hydraulic circuits to the tractor in the order in which the hoses are
labelled. The hydraulic circuits are designated with coloured rings (see Fig. 4).
