25
|
38
MACHINE MAINTENANCE AND REPAIRS
11 MACHINE MAINTENANCE AND REPAIRS
Observe the safety instructions for treatment and maintenance.
•
If it is necessary to weld during the repair and have the machine connected to the tractor, it
must have disconnected supply cables from the alternator and the accumulator.
•
Check the tightening of all screw and other assembly connections at the machine before every
use of the machine, furthermore continuously as needed.
•
Continuously check the wear of the working bodies of the machine, possibly replace these
worn working bodies with new ones.
•
Adjustment, cleaning, and lubrication of the machine may only be performed with the
machine at rest (i.e. the machine is standing and not working).
•
When working on a lifted machine, use suitable support equipment supported at marked
points or at points suitable for that.
•
During adjustment, cleaning, maintenance, and repair of the machine, you must secure those
parts of the machine that could endanger the operator by falling or another movement.
•
For catching the machine during handling using lifting equipment, use only the places marked
with self-adhesive labels with the chain sign.
•
Upon a failure or damage of the machine, immediately turn off the tractor's engine and
secure against restarting, secure the machine against movement ? only then you can remove
the failure.
•
During repairs of the machine, use exclusively the genuine spare parts, suitable tools and
protective equipment.
•
Keep the machine clean.
Do not clean bearings with a high-pressure cleaner or direct water stream. The seals and
bearings are not watertight at high pressure.
11.1 Tightening and securing the disc bearings (does not apply to
maintenance-free bearings)
•
First of all, tighten the screw nut and move the block around so that the bearings fit in the
block. After that release the screw nut and tighten it again by 32Nm pulling torque.
Furthermore, the screw nut has to be secured by snapping it into the shaft groove.
Содержание DISKOMAT 3 N
