Farm King 1370, Руководство оператора и каталог запасных частей

Страница: 49 / 146

Maintenance - 1370, 1385, 1395, 13114 Backsaver Auger
47
LUBRICATION
Recommendations
Always use a good quality multi-purpose / lithium
base grease when lubricating the equipment.
• Always use a hand-held grease gun.
• Clean fitting before greasing, to avoid injecting dirt
and grit.
• Replace and repair broken fittings immediately.
• If fittings will not take grease, remove and clean
thoroughly. Replace fitting if necessary.
IMPORTANT
Fluid such as engine oil, hydraulic fluid,
coolants, grease, etc. must be disposed of in an
environmentally safe manner. Some regulations
require that certain spills and leaks on the ground
must be cleaned in a specific manner. See local,
state and federal regulations for the correct
disposal.
Locations
Lubricate the following grease locations EVERY 8
HOURS:
Figure 33
Apply two pumps of grease to the (Item 1) [Figure
33] .
Lubricate the following grease locations EVERY 50
HOURS:
NOTE:
The PTO shaft is equipped with extended
life bearings. Do not over-grease.
Figure 34
Apply two to three pumps of grease to the cross
and bearings (Item 1) on the PTO driveline
[Figure
34] .
Figure 35
Apply two pumps of grease to the guard bushings
(Item 1)
[Figure 35] .
Apply eight to ten pumps of grease to the
telescoping member (Item 2)
[Figure 35] .
1
1 1
2
2-3
2
8-10
1
1
1
2
2