©
2010
HID
Global
Corporation
All
rights
reserved
DTC1000/DTC4000
Card Printer/Encoder User Guide (L001398, Revision 1.2)
104
Section 8: Cleaning
The Card Printer is built to require a minimum amount of maintenance. Nevertheless, there are a few
procedures you can perform on a regular basis or as needed to ensure the best possible performance
Safety Messages (review carefully)
Symbol
Critical Instructions for Safety purposes
Danger:
Failure to follow these installation guidelines can result in
death or serious injury.
Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).
•
To prevent personal injury
, refer to the following safety
messages before performing an operation preceded by this
symbol.
•
To prevent personal injury
, always remove the power
cord prior to performing repair procedures, unless otherwise
specified.
•
To prevent personal injury
, make sure only qualified
personnel perform these procedures.
Caution:
This device is electrostatically sensitive. It may be
damaged if exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).
•
To prevent equipment or media damage
, refer to the
following safety messages before performing an operation
preceded by this symbol.
•
To prevent equipment or media damage
, observe all
established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.
•
To prevent equipment or media damage
, always wear an
appropriate personal grounding device (e.g., a high quality
wrist strap grounded to avoid potential damage).
•
To prevent equipment or media damage
, always remove
the Ribbon and Cards from the Printer before making any
repairs, unless otherwise specified.
•
To prevent equipment or media damage
, take jewelry off
of fingers and hands, as well as thoroughly clean hands to
remove oil and debris before working on the Printer.
