10
11
OPERATION
• Ensure the Battery Pack is fully inserted and locked in place in the Battery
Docking Port.
• Connect the Jack Adaptor to the
Charger Socket and then the Charger
into a wall outlet (ill.
j
). The Indicator
Lights will flash for 10 seconds before
showing the actual battery status (
Indicator lights).
NOTE:
-
The capability to charge the Battery
Pack is not affected by the appliance
state of assembly.
• Disconnect the Charger from the wall
outlet and then the Jack Adaptor from
the Charger Socket.
j
1.
2.
Indicator lights
Below table shows the different combinations of Indicator Lights.
Indicator lights Color
State
Remarks
1 flashing light
Blue
Charging
Battery level ≤ 25%
1 steady light and
1 flashing light
25% ≤ Battery level < 50%
2 steady lights and
1 flashing light
50% ≤ Battery level < 75%
3 steady lights and
1 flashing light
75% ≤ Battery level < 100%
4 steady lights
Plugged with full charge
In use
75% ≤ Battery level < 100%
3 steady lights
50% ≤ Battery level < 75%
2 steady lights
25% ≤ Battery level < 50%
1 steady light
Red
Battery level ≤ 25%
1 flashing light
Fault
Battery Pack needs charging
4 flashing lights
Defective Battery Pack, blocked motor or
Battery Pack charging issue
No light
None
Not in
use
Unplugged appliance / Depleted or missing
Battery Pack
OPERATION
Blending programs
The maximum blending times in the chart below are not approximate and should
be respected.
Button
Duration
Speed
Action
PULSE
max. 1 minute
max speed Rotate counterclockwise and hold;
release to stop
HIGH
max. 1 minute
high speed Rotate clockwise to start; rotate
counterclockwise to OFF position to stop
LOW
slow speed
NOTE:
-
Do not operate the appliance continuously for more than 1 minute. Do not
operate the appliance continuously for more than 15 seconds without load.
Allow the appliance to cool down for 3 minutes before using it again.
-
If used for 1.5 minutes, the appliance will switch off automatically. Allow the
appliance to cool down for 5 minutes before using it again.
-
Turn the Control Knob (PULSE OFF HIGH LOW) to OFF position to stop
operation and switch the appliance off.
Tips for ice crushing: When crushing ice, always add water until ice floats over the
blades. (Do not use anything except water to crush ice.)
Charging the Battery Pack
The Battery Pack for this appliance has been shipped in a low charge condition.
Charge it fully before first use.
NOTE:
-
The Battery Pack has a rated voltage of DC 14.8V. Before plugging the
charger into a wall outlet for charging, ensure that the electrical circuit is not
overloaded with other appliances.
WARNING:
-
Charge in a safe location away from moisture and heat sources!
-
Always charge the Battery Pack before storage!
Rechargeable Blender_BL 45312_IM_US_V10_190610.indd 11
6/10/19 10:24 AM
