Connecting to the Mains Water Supply
Water Pressure
Connecting to the water outlet
Inlet hose (Cold water supply)
For best operating results, incoming water
pressure should be between 0.04 MPa
and 1MPa. Incoming water supply for the
dishwasher is controlled by a ‘pressure switch’,
so if the household water pressure is low,
dishwasher fill time will increase or may not
operate.
WARNING
: Please close the hydrant after
using.
Insert the drain hose into a drainage pipe.
Attach the drain hose to the wall using the
supplied U-bend fitting. The end of the hose
should be dropped into a drainage pipe, the
height of which should be from 500mm to 1100
mm above the base of the dishwasher.
To allow for an air gap around the end of the
drain hose, the diameter of the drainage pipe
should be at least 40 mm.
The water inlet hose from the machine
terminates in a 3/4” female connector.
The water supply should therefore
terminate in a similar male connector
and should have a stopcock close by in
the pipe.
Connect the straight connector of the
inlet hose to the water supply securely
ensuring that the washers are securely
in place at both ends of the hose.
min 120 mm
min 500 mm
ma
x 1100 mm
min 40 mm
GB-9
GB-8
ENGLISH
ENGLISH
