Far Tools PRO ML 550, Руководство пользователя

Страница: 15 / 19

7.4.1 It is forbidden to change the direction after starting the motor. Be sure to change the direction after
stopping the machine.
7.4.2 After operation, don
’
t cut off the electricity supply directly and should stop the lathe first.
7.5 Lighting conditions: This machine tool isn’t disposed the lighting, customers’ dispose the lighting condition
by themsevve. The lighting equipment should be 600 LUX. It should not lead to dangerous frequency flash
and should not take place the appearance of disturbing dizzy, shade area and it should be according to
EN60204-1.
8. Safe protection, safe operation of the machine tool.
8.1.1 A position switch is disposed on the gear change cover to lock with the main
shaft electric circuit each other, When operation will change the speed or exchange the gears. Open the back
cover the main electric. circuit shut off by itself. So can safety operation. After the cover is closed, the main
electric circuit is reput through by the magnetic switch, the machine tool can work normally.
8.1.2 Safe protection of the main spindle chuck protective cover is disposed on the main spindle chrck to
lock, with main electric circuit each other upon you open the protective cover, the main electric circuit can be
put through by opening the magnetic switch.
8.1.3 Safe protection of longitudinal leading screw longitudinal leading screw is disposed a sealed cover. It
can not only safeguard the precision of the leading screw but also avoid the dangerous of the leading screw
twine the hair and clothes.
8.1.4 Safe protection of the carriage. Avoiding the dangerous of twining and spraying when running.
8.1.5 Don’t proceed the workpiece exceeding the design capacity of the machine tool. When the long-thin
shaft stretch out the back of spindle. Please remove the screw and cover on back take the safe protection
measures by yourself to avoid the dangerous owing or rotation of the workpiece. After finishing work, please
reset and tightly the back cover. Please note the warning brand.
8.1.6 When turning the thread of 2mm pitch, select the spindle speed less than 390rpm to avoid the dange-
rous of twining the clothes owing to the hand wheel out-of –speed.
8.1.7 A position lump is disposed on end face of bed’s guide way to avoid sliding of the tailstock.
8.1.8 Chuck wrench has automatic leap back system. Once fixing the work piece wrench leap back automa-
ticly, avoiding the dangerous of forgetting to put down the wrench.
8.2 Safe Operation.
8.2.1 Operators must mot wear oversized clothes and gloves, tie up the hair in case of accident wearing
protective glasses.
8.2.2 Changing cutter or measure the workpiece, the first is stopping the machine.
8.2.3 Operators can not leave from machine, only in the time of leaving in the condition of stopping the
machine the tool and shutting the power supply.
8.2.4 In the time of operating, if there is unormal moise, operator must stop the machine and maintain it.