Step 3: Removing hanging shell
A.Use a screwdriver to remove the 4 screws on both sides and separate the rear case from the wall
bracket, as shown in Figure 3-4.
B.Use a screwdriver to remove the 6 screws on the back of the rear case and separate the rear case.,
as shown in Figure 3-5.
'JHVSF
'JHVSF
Ӫ
i33VF
Use a screwdriver to remove the 6 screws on the back of the rear case and separate the rear case,
as shown in Figure 3-6.
Figure 3-6
Step 4: Install the wall bracket, wiring and casing
A.Align the screw holes of the wall bracket with the holes in the wall and fix them to the wall with
the TA5 x40mm screws, as shown in Figure 3-7.
B.Pass all the wires through the silicone plug in the middle of the bottom case. All lines should be
reserved for 15~20CM length, as shown in Figure 3-8.
Note:
The outlet hole of the bottom case faces down.
Figure 3-7
Figure 3-8
Ӫ
i33V
Ӫ
i33V
