3. Charging
Charging your charging case:
When charging, the LED on the Charging Case will flash blue to indicate that the Charging Case is
charging. It is fully charged when all 4LEDs on the Charging Case are lit.
Note: You can charge your Carging Case with or without the Earbuds inserted.
Charging your earbuds:
(need to close the charging case.)
1) Place your Earbuds into the Carging Case and make sure they sit comfortably in the magnetic
Charging Docks.
2) A red LED light will light up on each Earbud to indicate that the Earbuds are charging, and the blue
LED light will light up on the Charging Case at this time. The all LEDs light will turn off once the
Earbuds are fully charged.
4. Turing On/Off and Pairing
4.1 Two Ways to Turning on and Pairing:
1) Open the charging case, the earbuds will turn on and pair automatically.
Open the charging case and wait for 3-8 seconds. The earbuds will establish a connection with each
other, and you can hear the sound
“
Power on
”
and
“
Connected
”
.
Next, the LEDs of the Master Earbud will flash blue and red, this means "IP8-X" is attempting to
establish a connection with your phone. The LED on the Second Earbud will turn off.
2) You have to reset the connection between the Earbuds if they fail to pair, or when the power of the
charging case is less than 10%, the charging case will remain in the protection mode. In this case,
simply follow these steps:
2-1) Make sure both Earbuds are swithched off.
2-2) Press and hold both earbuds multi-function button for 2-5 seconds until the Earbuds LEDs flash
in red and blue.
2-3) After 3-8 seconds the earbuds will establish a connection with each other; the LEDs of the
Master Earbud will flash blue and red, while the LED on the Second Earbud will turn off.
4.2 Turning Off:
1) In the power-on state, press the multi-function button of any one of the earbuds for 2-5 seconds to
turn off.
2) Inserting the Earbuds into the Charging Case swithches them off and allows them to recharge.
3) Under the pairing, if there is no phone to be connected, after the LED red and blue flashes for 120
seconds, the earbuds will also automatically turn off.
5. Connect your device
5.1 Connect your device for the first time:
After turning on both Earbuds (as explained in the chapter 'Turning On/Off and Pairing'), connect your
device with "IP8-X" via your device's Bluetooth setting page. The LED on the Master Earbud will stop
flashing, and the Earbuds are now ready to use.
5.2 When previously paired with a device, IP8-X will automatically attempt to reconnect to this device
after being switched off and on.