Fantic XX 125, Руководство по эксплуатации и обслуживанию

Страница: 140 / 153

4. Maintenance
USE AND MAINTENANCE MANUAL CHAPTER 4
MAINTENANCE 2-Strokes - Edition 00 / 2023
139
4
4.10 WHEELS
Spokes check and tightening
The following procedure applies to all spokes of both
wheels.
– Check that the spokes are not broken or deformed, if they
are, they must be replaced;
– Check the tension of the spokes by tapping on them with a
screwdriver. A well tightened spoke will emit a light, tinkling
tone, while a loose one will emit a deaf tone. In the case of a loose
spoke, tighten it with a spoke wrench to the specified torque;
Spokes (XX 125 and XE 125 versions) :
2.5 Nm (0.25 m•kg, 1.8 ft•lb)
Spokes (XX 250 version) :
2.5 Nm (0.25 m•kg, 1.8 ft•lb)
Be sure to tighten the spokes before and after the
running-in.
Wheel check
The following procedure applies to both wheels.
– Place a stand under the engine, lift the wheel and turn
it. Check the centering and alignment of the rim channel
with respect to the wheel hub. If there are any anomalies,
proceed with the correction by pulling the spokes;
– Check the wheel bearings for axial and/or radial clearance,
replace the bearings if present.
If there are cracks or splits in the rim channels, it is
necessary to replace them.
Never try to repair the wheel rims.