13
fantech
Airflow balancing
(cont'd)
1
Cut hole in duct and insert flow measuring
station. Make sure that the flow measuring
station’s air direction arrow points in the
direction of the airflow. Secure the flow
measuring station with duct tape.
2
Before taking the reading, make sure that
the magnehelic gauge is level and at 0.
Refer to the flow measuring station’s
chart to determine your unit’s airflow
velocity.
3
Adjust the “Supply Air Out” damper until
you reach the desired velocity. Follow
steps 1-3 to adjust the “Exhaust Air Out”
damper, if needed.
Measure
here
Minimum
457mm
(18")
Measure
here
Minimum
457mm (18")
• To avoid airflow turbulence and incorrect
readings, the airflow velocity should be
measured on a section of steel ducting.
Reading should also be taken at a minimum
distance of 457mm (18") from the unit or
elbow. Measurement should also be made
prior to any transition in the duct work so
entire airflow is measured.
Measuring the airflow using station (grid) method
Adjusting airflows
A damper is integrated into the Fresh Air to Building collar. This damper replaces the installation of a separate
damper into the Fresh Air to Building ducting line.
The damper-collar is pre-set in the fully opened position. If the procedure requires a reduction in airflow to the fresh
air duct, simply turn positioning knob located on the side of the collar clockwise until desired airflow is obtained. The
damper position can be determined by the orientation of the pointers situated on the side of the damper. The damper
is fully open when the pointers are towards the top of the collar (as shown in picture) and fully closed when they are
sideways.
Once procedure is completed, install a piece of tape over positioning knob to avoid any tampering by the home owner.
Do not turn positioning knob counterclock wise when dampers are fully opened as damage may occur to the mechanism
Содержание SER 1504
Страница 15: ...15 fantech Wiring Diagram SER1504 SER2004 ...
Страница 16: ...16 fantech Wiring Diagram SER3205D ...
Страница 22: ...22 fantech Notes ...
Страница 23: ...23 fantech Notes ...