Front Side of Housing -
Corresponding
6.
Fiber Optic Cable Plate-
a.
When installed on the housing, the fiber optic cable plate and the two adaptors inserted
inside it allow for an easy attachment of 2 fiber opt
instructions, please refer to the section “
b.
Remove the fiber optic cable plate from the housing in order to make use of the internal
camera flash during your dive. In order to remove the plate, insert
adaptors installed inside the plate and pull the plate upwards till it is removed from its slot.
Note that when photographing using the camera built
accessory should be installed, or else unwanted
c.
Make sure the fiber optic cable plate i
avoid losing it during the dive.
d.
If using only one external flash
place to block any light coming out of the exposed adaptor hole.
9.
Tripod Mounting Screw Holes
(bottom)
10. Lanyard Loop
FRX100 VA R Housing Instruction Manual
8
Corresponding numbered descriptions are found below the image
on the housing, the fiber optic cable plate and the two adaptors inserted
inside it allow for an easy attachment of 2 fiber optic cables to the housing. For further
instructions, please refer to the section “External Flashes”.
Remove the fiber optic cable plate from the housing in order to make use of the internal
flash during your dive. In order to remove the plate, insert your fingers beneath the
adaptors installed inside the plate and pull the plate upwards till it is removed from its slot.
when photographing using the camera built-in flash only, the flash diffuser
accessory should be installed, or else unwanted shading will occur in most images taken.
Make sure the fiber optic cable plate is secured to the housing by its secure line
avoid losing it during the dive.
If using only one external flash, make sure the second fiber optic cable adaptor rema
place to block any light coming out of the exposed adaptor hole.
Tripod Mounting Screw Holes
(bottom)
Instruction Manual 20200225
below the image
on the housing, the fiber optic cable plate and the two adaptors inserted
ic cables to the housing. For further
Remove the fiber optic cable plate from the housing in order to make use of the internal
your fingers beneath the
adaptors installed inside the plate and pull the plate upwards till it is removed from its slot.
in flash only, the flash diffuser
shading will occur in most images taken.
s secured to the housing by its secure line in order to
make sure the second fiber optic cable adaptor remains in its
6.
Fiber Optic
Cable Plate
7.
Control Ring
8.
Lens Port
