Fanstel ST250, Руководство пользователя

Страница: 9 / 27

Page 6
#00
- - - -
OUTSIDE ACCESS?
#00
9 - - -
OUTSIDE ACCESS?
(A) If you don’t need to dial a number to access an
outside line, press the
Dial/Enter
button and go to
Step 9.
(B) Alternatively, enter the outside line access code (up
to 4 digits), press the
Dial/Enter
button and go to
Step 9.
(C) If you enter an outside line access code by mistake, press the
Delete
button or the
W button to delete the digits.
The outside line access code is dialed prior to any number
over 6 digits stored in the directory, memory buttons, or
the caller ID memory. A stored number with 6 or fewer
digits is considered an inside number. The outside line
access code is not dialed for an inside call. A PAUSE period or 3 seconds delay is
inserted automatically between the outside access code and the phone number.
9. Press
the
Menu
or
Save
button to save these operating settings and to exit the menu
mode.
10. After installation, lift the telephone's
Handset
and listen for the dial tone. If there is no
dial tone, check to make sure all cords are firmly plugged into their jacks.
Note: Programming your area code will allow you to easily dial numbers that are in your
Caller ID list. See the Section “
Calling Back a Number from the Caller ID List”
for more
information on dialing calls from your Caller ID list.
Adjusting the Display Angle
You can optimize the LCD display by adjusting the viewing angle. To adjust the LCD
viewing angle, move the rear edge of the LCD module up or down.
Adjusting the Display Contrast
The display can be adjusted to suit the light level of your room and your viewing
preference. To make the contrast of the display lighter or darker, press the
◑
button to
the right of the screen until the desired contrast is reached.
Adjusting Handset Receiver Volume
To adjust the handset receiver volume:
1. Lift the handset and listen to the dial tone.
2. Press the right side of the
Volume
button to increase the receiver volume.
3. Press the left side of the
Volume
button to decrease the receiver volume.
4. Replace the handset when the desired receiver volume is reached.