Fanmaster IDH2-20, Инструкция по эксплуатации

Страница: 5 / 20

3. ASSEMBLING INSTRUCTIONS
Remove the heater from the carton. If the heater is damaged, please contact
Fanmaster or where you purchased the heater from.
IDH2-20: This heater only requires to install the plastic handle (see Fig 1.)
2. PRODUCT DESCRIPTION & SPECIFICATIONS
Pos. Description Qty
A Screw 2
B Washer 2
C Handle 1
IDH2-30 & IDH2-50: The following parts are supplied in the carton
Fig 1.
Pos. Description Qty
A Handle 1
B Screw 6 or 8
C Spring Washer 6 or 8
D Plain Washer 6 or 8
E Feet pipe Assembly 1
F Nut M5 6 or 8
G Nut M12 2
H Wheels 2
I Plain Washer 12 2
J Wheel Shaft 1
K Cotter Pin 2
Fig 2.
To assemble the heater, proceed as follows (see Fig 2.)
1. Insert the wheel shaft (J) to the corresponding holes of the feet pipe assembly (E).
2. Insert the cotter pin (K) to the corresponding holes. Put plain washer (I) to the two
sides of the shaft, slide the wheel (H) over the wheel shaft, screw the nut (G) to fix
the wheel on the shaft.
3. Put the heater body on the feet pipe assembly, line up the 4 holes of the handle
(A) ensuring handle is at the back of the heater, ensure holes line up with the feet
pipe assembly.
4. Using the screws (B), sping washer (C), plain washer (D) and nuts (F) fix the feet
pipe assembly & handle to the tank.