7
3.
Secure the ceiling canopy to the hanger bracket
with screws provided (screws shipped already
threaded into hanger bracket) (Figure 8). Your fan
is now wired to be turned on and off from the fan pull
chain speed control.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring. Note:
If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
If separate control of light fixture (optional) is
desired, a separate switch leg from the outlet box is
required. In this instance the blue wire from the fan
will be connected to the light switch leg (typically red
wire)
INSTALLATION NOTE
2.
Securely connect the white fan motor wire to the
white supply (neutral) wire using wire connector
supplied. Securely connect the black fan motor wire
and blue wire to the black supply wire using wire
connector supplied (Figure 7).
After connections have been made, turn leads
upward and carefully push leads into the outlet
box, with the white and green leads on one side of
the outlet box and the black and blue leads on the
other side of the outlet box.
1.
Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the supply grounding conductor (this
may be a bare wire or wire with green colored
insulation). Securely connect wires with wire
connectors supplied.
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed
by a licensed electrician.
How to Wire Your Fan - Pull Chain
Operating Instructions - Pull Chain
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades is in place. Noise and fan
damage could result.
1.
Restore electrical power to the outlet box by
turning the electricity on at the main fuse box.
2.
Check the operation of the fan by gently pulling on
the pull chain switch. (Figure 9)
3.
If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Then slide the reverse switch to the opposite
position and turn fan on again. Your fan model is
equipped with a 4-position, 3-speed, pull chain
switch. The operating sequence is as follows:
1
st
Pull = HIGH
2
nd
Pull = MEDIUM
3
rd
Pull = LOW
4
th
Pull = OFF
Figure 7
Figure 8
Household
Supply
Listed
Outlet Box
Black
White
Blue
Green Wire
(Ground) from
Hanger Bowl
Green Wire
(Ground)
Black
Fan Wire
Green Wire
(Ground) from
Hanger Bracket
NOTE:
Diagram shows
wiring for single control
of fan & light
SCREW (2)
SPEED
CONTROL
PULL
CHAIN
REVERSING
SWITCH
Figure 9