6
To reduce the risk of fire, electrical shock, or
personal injury, mount fan to outlet box marked
acceptable for fan support, and use screws supplied
with outlet box. Most outlet boxes commonly used
for support of light fixtures are not acceptable for fan
support and may need to be replaced. Consult a
qualified electrician if in doubt.
WARNING
If your fan is to replace an existing light fixture, turn
electricity off at the main fuse box at this time and
remove the existing light fixture.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit. The
outlet box must be securely anchored and capable of
withstanding a load of at least 50 lbs.
Electrical Requirements
Wiring and Control Options
Please choose one of the following options and proceed
to the page as indicated.
1.
Standard 4-position, 3-speed, pull chain switch and
reverse slide switch, see page 7.
2.
Optional fan only wall slide control (C1), see page 9.
3.
Optional fan & light remote control (C4), see page 8.
4.
Optional fan & light slide wall control (C2) or optional
2-fan slide wall control (C5). Please see instructions
provided with control.
NOTE:
If you are using a Fanimation Light Fixture with your fan, see Ceiling Fan Light Kit Installation Instructions
(packed with light kit) for wiring.
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
WARNING
Turning off wall switch is not sufficent. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
DAMP LOCATION CEILING FAN:
If you have purchased a
Damp Location Ceiling Fan, you may only use light kits marked
suitable for use in damp locations.