6 to 9 in.
Hanger Bracket
5.
Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install the two set
screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully
tighten the nuts using a hex wrench. (Figure 5)
6.
Route wires and safety cable through motor
coupling cover, canopy screw cover and ceiling
canopy. (Figure 6)
7.
Reinstall the hanger ball on the downrod as follows.
Route the brown, blue, red, gray, yellow wires and
safety cable through the hanger ball. Position the pin
through the two holes in the downrod and align the
hanger ball so the pin is captured in the groove in the
top of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could cause fan
wobble. (Figure 7)
8.
Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 8)
9.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 9)
How to Assemble Your Ceiling Fan (Continued)
8
Figure 5
Set Screws
and Nuts (2)
Ceiling
Canopy
Motor Coupling
Cover
Canopy Screw
Cover
Downrod
Clevis Pin
Hairpin Clip
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
Figure 6
Figure 7
Figure 8
Figure 9
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
