5.
Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
7.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 7)
How to Assemble Your Ceiling Fan (Continued)
10
Canopy Screw
Cover
Ceiling Canopy
Motor Coupling
Cover
Figure 5
Hanger Bracket
Figure 7
Figure 6
4.
Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install and tighten
the two set screws with nuts in the downrod support.
Securely tighten the set screws with screwdriver then
fully tighten the nuts by hex wrench. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
6.
Reinstall the hanger ball on the downrod as follows.
Route the wires through the hanger ball. Position the
pin through the two holes in the downrod and align the
hanger ball so the pin is captured in the groove in the
top of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball.
A loose set screw could create fan
wobble.
(Figure 6)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
Figure 4
Hairpin Clip
Clevis Pin
Set Screws and
Locking Nuts (2)
Downrod