Fanimation Louvre FP1320 Series, Руководство пользователя

Страница: 10 / 16

Mounting the Fan Blades
You will fi nd the fan blade set packed in its own carton and the blade holders and hardware bag in the upper foam packing
in the fan box. The hardware bag for the blade holders consists of 10 screws and a Phillips head screwdriver.
1. Lay side “A” of the blade holder on a flat surface with the
inside of the blade holder facing up. This is the side with
the threaded posts and pitched foot.
2. Position the palm leaf, or the woven bamboo blade, or
the wicker blade over the blade holder with the threaded
posts showing. Make sure the bottom edge of the blade is
fully seated against the blade holder.
3. Place side “B” of the blade holder on top of the blade,
positioning the holes over the threaded posts.
4. With a Philips screwdriver, thread both screws into the
posts but do not fully tighten.
5. Prior to final tightening, position the centerline of the
blade holder with the center of the end of the blade.
6. Tighten both screws to secure the blade. (Figure 18)
NOTE: Optional Wood blades and Blades Holders,
Canvas blades and The Ococee™ kayak oar blades are
available for this assembly.
Figure 18
Figure 19
Side A
Fan Blade
Side B
Motor Housing
Blade Holder
Screw
(2 per blade holder)
10
Installing the Canopy Housing
1. Screw in two threaded rods into the Hanger Bracket
(Figure 17a).
NOTE: The threaded rods in the hanger bracket serves as
guides for easier installation.
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled knobs
supplied with your fan (Figure 17b).
Figure 17a Figure 17b
NOTE: Supply wires and fan wires omitted for clarity.
NOTE: This step is applicable after the neccessary wiring
is completed. (see pages 7, 8 or 9)
▲ WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
INSTALLATION NOTE
Attach the Blade Holders to the Motor Housing using
the holes marked #5. The two screws holding the Motor
Housing to the fan body will come mounted in #4 holes
and should remain in place. Two of the five blade holders
will cover these two screws.