6
Hanger
Bracket is
loose and
free to rotate
This Lag Bolt is NOT
fully fastened
Figure 1
Fan Alignment And Hanger Bracket Installation
1.
Preliminary Hanger Bracket Attachment (Figure 1):
Drill
¼
˝
pilot hole through the center of the junction box, into the
ceiling joist or structural member. Loosely attach hanger
bracket to the ceiling structure using
3
⁄
8
˝
x 4
˝
lag bolt and
fl
at washer.
DO NOT FULLY
TIGHTEN THE LAG BOLT
YET! Hanger Bracket should be free to rotate.
2.
Hang the Fan Assembly (assembled earlier) into the the
hanger bracket. Make sure the groove of the hanger ball is
positioned on the tab of the hanger bracket. (Figure 2)
3.
Carefully ROTATE
the
Hanger Bracket and Fan
Assembly together to orientate the fan in the desired
‘squared‘ position. (Figure 2)
4.
Carefully remove the Fan Assembly from the Hanger
Bracket.
NOTE:
If the Hanger Bracket rotates prior to tightening the
lag bolt, the fan will no longer be positioned properly.
4.
NOW, securely and fully tighten the lag bolt in the center
of the Hanger Bracket while being careful not to allow the
Hanger Bracket to rotate. (Figure 3)
▲
WARNING
Failure to follow these Hanger Bracket installation
procedures may result in damage to Hanger
Bracket.
Tab
Rotate both Hanger
Bracket & Fan
Assembly together
Figure 2
Figure 3
