Fanimation HUGH 44, Руководство пользователя

Страница: 7 / 38

How to Hang and Wire Your Ceiling Fan (continued)
x 6 WIRE
CONNECTORS
HARDWARE USED:
9. After splicing and making the wire connections, the
wires should be spread apart and turned upward with
the grounded conductor (white), the equipment
-grounding conductor (green) and safety cable on one
side of the ceiling bracket and the ungrounded conductor
(black and blue) on the other side of the ceiling bracket.
(Figure 7)
8. Connect wires using connectors as shown in
Figure 7.
7
Figure 6
Figure 5
fan wires omitted for clarity
NOTE: Supply wires and
5. Attach the safety cable to ceiling support cable.
Slide cable clamp onto safety cable (from fan). Place
the end of cable through the loop of ceiling support
cable. Pull as much cable through loop as possible.
Feed end of cable into clamp hole and firmly tighten
screw (Figure 5). Cut off excess safety cable.
6. Make sure the electrical supply wires, including the
ceiling bracket grounding wire and safety cable are
pulled through the downrod, between the ceiling
bracket and the junction box so that electrical
connections can be made later.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this
position.
7. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. If complete
the receiver code setting process, put the rubber cover
(included) in the receiver unit. (Figure 6)
Receiver Unit
Rubber Cover
Dip Switch
ON DIP
1 2 3 4 5
Figure 7
White Wire
from Supply
Green Wire
from Ceiling Bracket
Black Wire
from Receiver
White wire
from Receiver
BLK_ANT
Black Wire
from Supply
Blue Wire
from Motor
Black Wire
from Motor
Black Wire
from Receiver
White Wire
from Receiver
Blue Wire
from Receiver
White wire
from Motor
Green Wire
from Supply
Green wire
from Motor