8
1.
Remove the five rubber motor stops from the motor
assembly. Discard the stops and retain the screws
for the next step. (Figure 17)
Installing the Canopy Housing (continued)
How to Assemble the Blades and Light Plate Assembly
Figure 19
2.
Assemble the flywheel to the motor assembly using
the previously removed screws. (Figure 18)
x 15
x 15
FLAT WASHER
#8-32 x 8 mm
TRUSS WITH
HEAD SCREWS
HARDWARE USED:
3.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a Phillips screwdriver, tighten #8-32 x 8 mm
Truss head screws and flat washers to secure the
blade to the blade holder. (Figure 19)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
#8-32 x 8 mm
Truss head screws
and Flat Washer (3 each per blade)
BLADE
Blade Holder
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figrue 16)
Figure 16
Canopy Screw
Cover
Rubber motor
stops
Figure 17
Figure 18
Fly wheel
Fan Motor
Assembly